Description
A side-mounted, pre-wired solenoid point motor that clips directly to PECO OO/HO Setrack turnouts (left- or right-hand). It also works with OO/HO Streamline turnouts. The advantage over the under-baseboard PL-10: no 40 mm cut-out to drill, no soldering — just clip it on and run two wires.
How it works
- Clips to the side of any PECO OO/HO Setrack or Streamline turnout — no baseboard cut-out required.
- Pre-wired: connect to a 16 V AC accessory feed and a momentary switch (or CDU + push-button).
Pair it with
- PL-26 — passing-contact (stud-and-probe) panel switch.
- PL-13 / PL-15 — accessory microswitches for frog polarity or signal control.
- NCE Switch-It / Digitrax DS64 / similar stationary decoder — for DCC throttle control.
Specifications
- Type: Twin-coil solenoid point motor (side-mounted)
- Scale: OO / HO (16.5 mm gauge)
- Compatible turnouts: PECO Setrack ST-5, ST-6, ST-44, ST-241, ST-242, ST-244, ST-245 and equivalent OO/HO Streamline turnouts
- Operating voltage: 16 V AC, momentary (CDU recommended)
- Mounting: Surface, side-clip; no baseboard hole required
- SKU: PL-11